Bulk current injection probes are used to inductively couple large RF currents into conductors passing through. They come in two different styles, a clamping style that can be used for hard to access cable bundles and a window style to pass wires and cables through. Signal, control, and power circuits of EUT (equipment under test) are the conductors when testing for conducted immunity. Bulk current injection probes operate as a single turn primary, multiple turn secondary transformer, by placing low series impedance in the probed power line while pushing a functional signal to a 50ohm receiver. The ratio of output voltage into a standard load divided by the net current movingthrough the probe equals the current probe's transfer impedance.MIL-STD-461,IEC 61000-4-6, andISO 11452-4commonly require the injection of low-level RF signals and high-frequency current into wires and cable bundles, making a current injection probe an essential item to adhere to testing requirements.
Avalon Test Equipment carries a variety of bulk current injection probes from top manufacturers (Com-Power,A.H. Systems, and more) to meet your testing requirements. Rent from Avalon and Test With Confidence®.
3 Items in Grid 4 Items in Grid List
A.H. Systems ICP-521 Current Injection Probe
10 kHz–100 MHz
Teseq CIP 9136A Bulk Current Injection Test Clamp
Wide frequency range 10 kHz - 400 MHz High power handling (up to 1 kW) Ideal for automotive BCI testing e.g. ISO 11452-4, RTCA/DO-160 section 20, MIL-STD-461 and manufacture‘s requirements Meets IEC/EN 61000-4-6 Replacement for CIP 36A & 37A as specified in Defence Standard 59-41
A.H. Systems ICP-522 RF Current Injection Probe
1 MHz–400 MHz
Fischer F-120-9A Bulk Current Injection Probe
Bulk Current Injection Probe
Fischer F-120-1 Bulk Current Injection Probe
The Fischer Custom Communications FCC F-120-1 Bulk Current Injection Probe has been designed to extend the use of conducted immunity testing over the bandwidth of 10 kHz – 175 MHz
Fischer BCICF-1 Bulk Current Injection Probe Fixtures
Part of the test equipment required by most of the Bulk Current Injection test procedure specifications. Allows the user the quickly and easily calibrate the injection probe prior to performing compliance testing.
Fischer BCICF-2 Bulk Current Injection Probe Fixtures
Injection Probe calibration fixtures are a part of the test equipment required by most of the Bulk Current Injection Test Procedure Specifications. This test fixture allows the user to quickly and easily calibrate the injection probe prior to performing the compliance testing.
Com-Power CLCI-100 Current Probe
The Com-Power Current Injection Probes are used for RF conducted immunity testing per IEC 61000-4-6, CISPR 16-1-2, RTCA DO-160, and MIL-STD 461.
EMC Partner CN-BT6 Injection Probe
Current injection probe for requirements CS115 and CS116 of MIL-STD-461